Instead of "Trusted Application" settings: It may be necessary to configure the firewall so that it runs the SyncBackSE/Pro application with "SYSTEM" settings:Īllow IP In From Any to Any Where Protocol Is Any This is because the firewall is blocking the connection as the permissions for the SyncBackSE/Pro application (within the firewall) are being set to " Trusted Application" instead of " SYSTEM", which will give our application elevated privileges (that our program needs and ask for). In certain firewall configurations, users may encounter Connection Refused errors (#10061) when using SyncBackSE/Pro to establish a connection to a remote site. it cannot retrieve a directory listing or files. If you are using a Dynamic DNS program with your FTP server you may find that disabling passive in the DNS settings (and FTP server) and in SyncBack/SE will fix data transfer problems, i.e. You may find that using SSL encryption (assuming the FTP server support encryption) can solve problems where the router is "breaking" FTP commands. Always check that your routers firmware is up-to-date. This is done to pass the correct IP address, for example. Please note that many routers will intercept FTP commands and change them to try and help with the connection. Eventually the selection window appears but it's empty: You need to enable Passive mode, or the FTP server is behind a firewall that is not configured correctly
#NAMEBENCH ERROR OUTGOING REQUESTS WERE INTERCEPTED PASSWORD#
Not logged in: The username and/or password is not correct. Unable to connect: Connection time out: The hostname may be incorrect or the FTP server may be behind a firewall.Socket Error # 10052: The host you were connected to crashed and rebooted.Socket Error # 10039: There may be a problem getting the IP address for the hostname.You may also want to be sure you are using a passive connection.
![namebench error outgoing requests were intercepted namebench error outgoing requests were intercepted](https://vitalflux.com/wp-content/uploads/2017/12/angular-5-create-pwa-service-worker-1024x538.png)
Socket Error # 10038: If you are using Serv-U modify your FTP server settings so that the following are unticked: " Block anti time-out schemes", "Block FTP_bounce attacks and FXP", and "Block users who connect more than 6 times within 60 seconds for 30 minutes".the FTP server is no longer connected to the network.
![namebench error outgoing requests were intercepted namebench error outgoing requests were intercepted](https://www.vpncheck.org/wp-content/uploads/2021/08/vpncheck-surfshark-review-vpn-location-1024x592.png)
Socket Error # 10093: This can happen when the network connection goes down, e.g.Socket Error # 10061, Connection refused: The hostname is correct, but either the FTP server is not listening on the port, there is no FTP server running, or a firewall is blocking the connection.if you have entered something like then change it to my. Also, enter the hostname or IP address, not a URL, e.g. Socket Error # 11004, Unable to connect: Check to make sure there isn't a trailing or leading space character on the FTP hostname.Socket Error # 11001, Host not found: Check that the hostname or IP address has been entered correctly.When testing an FTP connection you may receive one of the following errors: SyncBackSE V4.0.8 and later, SyncBackPro, and SyncBackFree, use a different FTP engine and so return less cryptic error messages. This article provides information about common errors when using FTP with SyncBack V3 freeware or SyncBackSE V4.0.7 and earlier. Modified on: Mon, 1 Nov, 2021 at 12:59 PM Solution home Technical Articles File Transfer Protocol (FTP) Common FTP errors and Socket Error messages